UPONOR CONTROL SYSTEM KNX INTERFACE MANUAL - CONNECTING UPONOR CONTROLLER C-56 WITH MEDIA COUPLER TR131A/B
4
2 Preface
The Uponor KNX Interface Manual describes how to set up the
Uponor Controller C-56 and the Media Coupler TR131 to
communicate on the KNX interface.
2.1 Safety instructions
Warnings used in this manual
The following symbols are used in the manual to indicate special
precautions when installing and operating any Uponor
equipment:
Safety measures
Conform to the following measures when installing and operating
any Uponor equipment:
• Read and follow the instructions in the installation and
operation manual.
• Installation must be performed by a competent person in
accordance with local regulations.
• It is prohibited to make changes or modifications not
specified in this manual.
• All power supply must be switched off before starting any
wiring work.
• Do not use water to clean Uponor components.
• Do not expose the Uponor components to flammable
vapours or gases.
• We cannot accept any responsibility for damage or
breakdown that can result from ignoring these instructions!
Power
Technical constraints
2.2 Disposal
The Uponor Control System consists of various recyclable
components. Uponor would be grateful if the components
(batteries, plastics, and electric or electronic parts) are sorted and
disposed of at a suitable recycling centre.
3Description
3.1 Overview
The Uponor Controller C-56 Radio can be connected to a
standard KNX bus via a Media Coupler TR131. This device will act
as a bridge between the Uponor Controller C-56 Radio and the
KNX wired bus. Programming of the Media Coupler TR131 and
the Uponor Controller C-56 Radio in ETS requires a plug-in
program.
The KNX interface offers several possibilities to operate and
monitor the Uponor Controller C-56 Radio in a KNX system such
as:
• Access to setpoints for every zone
• Readout of room and floor temperatures
• Alarm monitoring
• Usage of standard KNX devices for room temperature and
setpoint handling
3.2 Target group
The target group for this manual is an installation engineer that
has a basic knowledge and training on the ETS tool and KNX
systems. This is needed to do a full KNX installation of a Uponor
Controller C-56 Radio and Media Coupler TR131.
3.3 Scope
This manual describes the Controller C-56 Radio parameters that
are presented via the KNX interface. It also covers some Uponor
Controller C-56 Radio specific points that need to be considered
when using the standard KNX configuration tool, ETS.
The installation of the Media Coupler TR131 and the Uponor
Controller C-56 Radio are covered by separate installation
manuals that are delivered together with these products.
WARNING!
Risk of injury. Ignoring warnings can cause injury or
damage components.
CAUTION
Ignoring cautions can cause malfunctions.
WARNING!
The Uponor system uses 50 Hz, 230 V AC power. In
case of emergency, immediately disconnect the power.
CAUTION
To avoid interference, keep installation/data cables
away from power cables of more than 50 V.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais